Locks | DMS Components

Please select your desired length, and variant to produce the catalogue number for your product. Please use the provided chart image to get full measurement breakdown for your selected catalogue number.Download Full PDF View CAD LibraryBecause Guide Locks can be used inside the mold as well as at the parting line, DMS has added a jack screw hole to the male interlock. This allows removal without damage to the mold. Also added is a 5° angle on each end of the male.Male: AISI D2 (58-60 Rc) - Titanium Nitride Coated 78-80 RcFemale: AISI 1045 (60-62 Rc) - Black Oxide Finish

Round Tapered Interlocks

Please select your desired length, and variant to produce the catalogue number for your product. Please use the provided chart image to get full measurement breakdown for your selected catalogue number.Download Full PDF View CAD LibraryDMS round tapered interlocks provide positive alignment of cavities and cores.Extra grind stock is provided at the back of both male and female for positive fitting.

Side Locks

Please select your desired length, and variant to produce the catalogue number for your product. Please use the provided chart image to get full measurement breakdown for your selected catalogue number.Download Full PDF View CAD LibraryMale half: O-6 steel (58-60 Rc) - Black Oxide FinishFemale half: S-7 steel (54-56 Rc) - Titanium Nitrided (80 Rc)Supplied with socket head cap screws. Sold in sets only.

Square Interlocks

Taper Bar Locks

Please select your desired length, and variant to produce the catalogue number for your product. Please use the provided chart image to get full measurement breakdown for your selected catalogue number.Download Full PDF View CAD LibrarySOLD ONLY IN SETS**** When ordering, use SET CODE Example: MFTBL-2 (Supplied with MTBL-2 & FTBL-2)DMS Tapered Bar Locks provide positive alignment between mold halves.They maintain alignment while allowing for thermal expansion.Made of 1045 steel hardened to 58-60 HRc.Male and Female mounting pockets should be accurately aligned, flat and parallel to the parting line.The pocket lengths should be long enough to provide clearance.

Top Locks